Body Control Module Programming and Setup

BODY CONTROL MODULE PROGRAMMING AND SETUP

BODY CONTROL MODULE (BCM) REPLACEMENT
If the body control module (BCM) is replaced, the following procedures must be performed in the following order:
1. BCM Reprogramming-Refer to Body Control Module (BCM) Programming/RPO Configuration in Computer/Integrating Systems.
2. Learning the restraints ID-Refer to Body Control Module (BCM) Programming/RPO Configuration in Computer/Integrating Systems.
3. Theft Learn-Refer to Programming Theft Deterrent System Components in Theft Deterrent. A new BCM will learn the Passlock(TM) information automatically but the PCM must still learn the theft information from the BCM.
4. Program Key Fobs-Refer to Transmitter Programming in Keyless Entry.

BCM REPROGRAMMING
If the body control module (BCM) is reprogrammed, the following procedures must be performed
1. BCM Reprogramming-Refer to Body Control Module (BCM) Programming/RPO Configuration in Computer/Integrating Systems.
2. Learning the restraints ID-Refer to Body Control Module (BCM) Programming/RPO Configuration in Computer/Integrating Systems.
3. Theft Learn-Refer to Programming Theft Deterrent System Components in Theft Deterrent.
4. Program Key Fobs-Refer to Transmitter Programming in Keyless Entry.

INFLATABLE RESTRAINT SENSING AND DIAGNOSTIC MODULE (SDM) REPLACEMENT
If the sensing and diagnostic module (SDM) is replaced, learning the restraints ID procedure needs to be performed. Refer to Body Control Module (BCM) Programming/RPO Configuration in Computer/Integrating Systems.

PASSLOCK(TM) SENSOR REPLACEMENT
If the Passlock(TM) Sensor is replaced perform the theft learn procedure. Refer to Programming Theft Deterrent System Components in Theft Deterrent.

KEY FOBS REPLACEMENT
Refer to Transmitter Programming in Keyless Entry for the proper procedure.