Pinpoint Test V: THE MODULE DOES NOT RESPOND TO the JAGUAR APPROVED DIAGNOSTIC SYSTEM -'PHONE MODULE

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Jaguar S-Type, 2007 Jaguar S-Type, 2006 Jaguar S-Type, 2005 Jaguar S-Type, and 2004 Jaguar S-Type. However, it is still accessible from the selected car via links, so may be relevant.

CHECK THE 'PHONE MODULE FOR DAMAGE
INSPECT the 'phone module for damage.

Does the 'phone module indicate any signs of damage?

YES: INSTALL a new 'phone module. Refer to Cellular Phone . CLEAR the DTC. TEST the system for normal operation.

NO: Go to step 2.
CHECK THAT THE TESTER IS COMMUNICATING WITH THE ICE HEAD UNIT
Turn the ignition switch to the ON position.

Attempt to connect to the ICE head unit using the Jaguar approved diagnostic system (where available).

Can the tester connect to the ICE head unit?

YES: Go to step 3.

NO: Carry out the SCP test for the ICE head unit. (Pinpoint Test G: THE MODULE DOES NOT RESPOND TO THE JAGUAR APPROVED DIAGNOSTIC TESTER - ELECTRONIC PARK BRAKE (EPB) MODULE ).
CHECK THAT THE 'PHONE MODULE IS COMMUNICATING WITH THE ICE HEAD UNIT
Turn the ignition switch to the ON position.

Press the 'phone hard key.

High-line vehicles - Is the 'phone screen displayed? Low-line vehicles - Is the 'phone icon displayed?

YES: Go to step 4.

NO: Carry out the D2B diagnostic test procedure. (Pinpoint Test S: THE MODULE DOES NOT RESPOND TO THE JAGUAR APPROVED DIAGNOSTIC TESTER - INTRUSION SENSOR ).
CHECK THAT THE 'PHONE MODULE IS RESPONDING TO DIAGNOSTIC COMMANDS
INSTALL a new 'phone module. Refer to Cellular Phone .

Turn the ignition switch to the ON position.

Attempt to communicate with the 'phone module.

Can the tester communicate with the 'phone module?

YES: CLEAR the DTC. TEST the system for normal operation with the substitute 'phone module.

NO: INSTALL a new ICE head unit. Refer to Audio Unit . Refit the original 'phone module. CLEAR the DTC. TEST the system for normal operation