Front Electronic Module

Front Electronic Module (FEM) (86.80.41)

Removal
1. Disconnect the battery ground cable.

CAUTION:
- Prior to removal of the module, it is necessary to upload module configuration information to the Jaguar approved diagnostic system. This information needs to be downloaded into the new module once installed.
- Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.

2. Remove the left-hand side trim panel.
3. Reposition the floor covering.







4. Disconnect the electrical connectors.







5. Remove the front electronic module (FEM).







Installation
1. To install, reverse the removal procedure.
- Tighten to 10 Nm.