DTC P0894-07: Transmission Component Slipping - Mechanical failures: Action
NOTE:
The All Wheel Drive System Pump Bleed routine must be performed after all rear drive unit hydraulic system repairs.
- Refer to the relevant article of the workshop service information and check the rear drive unit hydraulic fluid level
- Check the rear drive unit hydraulic pipes for damage/blockages
- Using the Jaguar Land Rover approved diagnostic equipment, reconfigure the all wheel drive control module with the latest level software
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest. If the fault persists, install a new power transfer unit. For additional information, refer to:
Power Transfer Unit - INGENIUM I4 2.0L Diesel, Vehicles With: Active Driveline ,
Power Transfer Unit - INGENIUM I4 2.0L Diesel, Vehicles Without: Active Driveline .
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest. If the fault persists, install a new all wheel drive control module. For additional information, refer to: DIFFERENTIAL CONTROL MODULE - VEHICLES WITH: ACTIVE DRIVELINE .