Power Steering Control Module (PSCM)

CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.

NOTE:

If a control module or a component is at fault and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures service information, or determine if any prior approval program is in operation, prior to the installation of a new module/component.
Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last 2 digits give extra information read by the manufacturer-approved diagnostic system).
When performing voltage or resistance tests, always use a digital multimeter that has the resolution ability to view 3 decimal places. For example, on the 2 volts range can measure 1 mV or 2 K Ohm range can measure 1 Ohm. When testing resistance always take the resistance of the digital multimeter leads into account.
Check and rectify basic faults before beginning diagnostic routines involving pinpoint tests.
Inspect connectors for signs of water ingress, and pins for damage and/or corrosion.
If DTCs are recorded and, after performing the pinpoint tests, a fault is not present, an intermittent concern may be the cause. Always check for loose connections and corroded terminals.
Check JLR claims submission system for open campaigns. Refer to the corresponding bulletins and SSMs which may be valid for the specific customer complaint and complete the recommendations as required.
BEFORE starting any repairs or investigations of power steering issues, first download and retain the session file using the Jaguar land rover Approved Diagnostic Equipment. Where possible, check if the timeframe of any stored DTCs coincides with customers' reports both of the onset of steering system fault symptoms and with the technical nature of the reported symptoms.
During normal vehicle operation steering assistance may be temporarily reduced in a controlled way under some circumstances. When diagnosing potential steering assistance issues, first check if the customer reported symptom relates either to one of these circumstances (as described in the relevant Description and Operation article in the workshop service information, see article POWER STEERING ), or, to one of the following circumstances: an over temperature condition due to exceptionally demanding steering inputs; the vehicle power supply being in a low state of charge; CAN network signals required from other vehicle systems being unavailable or invalid

The table below lists all Diagnostic Trouble Codes (DTCs) that could be set in the Power Steering Control Module (PSCM). For additional diagnosis and testing information, refer to the relevant Diagnosis and Testing article in the workshop service information. For additional information, refer to: POWER STEERING .