DTC B10A2-32: Crash Input - Signal low time < minimum: Action

NOTE: The FlexRay wiring harness must not be repaired by making a localised wiring repair. A new wiring harness should be installed.

Using the Jaguar Land Rover approved diagnostic equipment, check the restraints control module for related DTCs and refer to the relevant DTC index
Refer to the appropriate System Wiring Diagram(s) and check the crash signal circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
Using the Jaguar Land Rover approved diagnostic equipment, perform a CAN network integrity test. Refer to the appropriate System Wiring Diagram(s) and check the high speed CAN bus (chassis) circuit for short circuit to ground, short circuit to power, open circuit, high resistance.
Repair the wiring harness as necessary Refer to the appropriate System Wiring Diagram(s) and check the FlexRay bus circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
Refer to the appropriate System Wiring Diagram(s) and check the restraints control module power and ground circuits for open circuit, high resistance. Repair the wiring harness as necessary