DTC P2586-13: Turbocharger Boost Control Position Sensor "B" Circuit - Circuit open: Action

NOTE: Operational requirements needed to allow the monitor to be fully tested. Drive the vehicle over 3 drive cycles (engine on/off) across urban cycles during which time the turbocharger boosts in order to confirm the repair

Using the manufacturer approved diagnostic system check datalogger signal
- Boost Pressure Actuator Bank 2 - Measured Position (0x0347)
Refer to the appropriate System Wiring Diagram(s) and check the variable geometry turbocharger vane actuator on bank 1 for open circuit, high resistance
Check and install a new variable geometry turbocharger vane actuator as required
Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest