DTC P2047-13: Reductant Injection Valve Circuit/Open (Bank 1 Unit 1) - Circuit open: Action

NOTE: A fault clear is NOT sufficient to clear the vehicle 'inducement' system warnings. The 'inducement' warnings automatically clear ONLY upon confirmation of the repair by the vehicle OBD system. The monitoring MUST be executed. The electrical checks normally occur once ignition is on or after engine start

Prioritized Checks to Perform
- Refer to the appropriate SYSTEM WIRING DIAGRAMS information and check the diesel exhaust fluid injector circuit for open circuit, high resistance
- Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
- Check and install a new diesel exhaust fluid injector as required
Vehicle Conditions to enable DTC Logging Strategy
- Engine running
- On completion of the previous repair actions the following MUST be carried out
- Using the Jaguar Land Rover Approved Diagnostic Equipment, clear the DTCs and retest
- NOTE: The engine MIL is OFF (when engine ON)
- Start engine
- The 'inducement' warning clears automatically once the monitoring has executed and passed with no malfunction. This terminates the drive cycle
- NOTE: If the engine MIL shows during the driving cycle, then the malfunction has reoccurred. Further repair is required
- Using the manufacturer approved diagnostic system clear all stored DTCs using the 'Diagnosis Menu' tab
- NOTE: This clears the fault storage from P2BAE/P2BAF