DTC U3000-05: Control Module - System programming failures: Action

NOTE:

This DTC will log with the following message displayed in the instrument cluster - Air suspension not in customer mode'. Do NOT replace any parts if only this DTC is logged. Follow the routine below.
When connected, the Jaguar Land Rover approved diagnostic equipment will read the correct Vehicle Identification Number (VIN) for the current vehicle and automatically take the vehicle out of Transit mode if required

Connect the Jaguar Land Rover approved battery power supply to the battery
Connect the Jaguar Land Rover approved diagnostic equipment to the vehicle and begin a new session
Follow all the on screen instructions
Select 'ECU Diagnostics'
Select 'Chassis Control Module (CHCM)'
Select 'ECU Functions'
Select 'Suspension geometry set-up' and when prompted, select 'Normal mode'
Follow all on-screen instructions until the application completes successfully
Exit the current session
Disconnect the diagnostic equipment and battery power supply from the vehicle