DTC U0102-87: Lost Communication With Transfer Case Control Module - Missing message: Action
NOTE:
Any short circuit, open circuit, or high resistance faults detected on the FlexRay harness should be repaired in accordance with the Jaguar Land Rover approved wiring harness repair procedure maintaining 90 to 100 ohms across the FlexRay network, maintaining the wire twist rate (20 mm+/-2 mm for one full 360° twist), using no more than of five in-line connectors on each branch of the FlexRay network. For further information refer to WIRING HARNESS (G1823735)
.
- Prioritized steps to perform:
- Refer to the electrical circuit diagrams and check the transfer case control module power and ground circuits for open circuit, high resistance. Repair the wiring harness as necessary
- Refer to the electrical circuit diagrams and check the FlexRay bus circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, check the transfer case control module for related DTCs and refer to the relevant DTC index