Current Flow
- Remove positive and negative wire connectors from coil. Connect ammeter between positive terminal of coil and disconnected positive primary wire.
- Connect jumper wire from negative terminal to ground. With ignition on, current flow should be approximately 7 amps. Replace ignition coil if current exceeds 7.6 amps.
- Connect ammeter to coil positive terminal and remove jumper wire from negative terminal. Connect coil Green wire to negative terminal. Current flow should be approximately 4 amps.
- If less than 3.5 amps, check for poor contact at 3-wire and 4-wire connectors or distributor ground screw. If current flow is greater than 5 amps, control unit is defective and must be replaced. Normal current flow with engine running is 2.0-2.4 amps. Replace control unit if not to specification.