LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1992 >> Wrangler Base, 2.5 P >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Synchronization Signal Generator >> Removal & Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Removal & Installation

  1. Remove distributor cap, rotor, and distributor. Remove pulse ring mounting screws and remove pulse ring. Using pin punch and hammer, remove distributor gear roll pin.
  2. Using a rubber mallet, tap distributor shaft out until distributor gear and shim are removed. Slide shaft out of distributor housing. Remove sync (synchronization) signal generator stator mounting screws and positioning arm.
  3. Slide wiring harness grommet out of distributor housing. Remove synch signal generator. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals