LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 1993 >> Wrangler Base, 2.5 P >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.5L & 4.0L >> Using DRB-II >> Service Reminder Indicator (Sri) Memory Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Service Reminder Indicator (Sri) Memory Test

NOTE: Perform SRI memory test only if referred here by diagnostic tests.
  1. To perform SRI memory check, ensure ignition is off. Attach DRB-II to engine diagnostic connector. Connector is located on left side (right side on Grand Cherokee) of engine compartment, near PCM. See Figure and Figure . Turn ignition switch to RUN position.
  2. Copyright information and diagnostic program version will appear on screen for a few seconds. After a few seconds DRB-II menu will appear. At FUEL/IGN MENU, press "5" (ADJUSTMENTS) key. Press ENTER key. At ADJUSTMENTS menu, press "4" (SRI MEMORY CHK) key. Press ENTER key. The DRB-II display will read SRI MEMORY CHECK ARE YOU SURE? (ENTER TO CONTINUE).
  3. Press ENTER key. The DRB-II will display SRI MEMORY TEST WRITE TEST [-------] and after a few seconds IS INSTRUMENT PANEL MILEAGE BETWEEN XXXXX AND XXXXX? (PRESS YES OR NO). If vehicle mileage is within specification, SRI memory check is complete. Press YES key. If vehicle mileage is not within specification, go to next step.
  4. Press NO key. DRB-II will display ENTER MILEAGE SHOWN ON INSTRUMENT PANEL (USE ENTER TO END) XXXXXXX. Enter vehicle mileage. DO NOT enter tenths. When correct vehicle mileage is entered, press ENTER key.
  5. DRB-II will ask for verification of mileage entry. If mileage entry was accurate, press ENTER key. DRB-II will display SRI MEMORY CHECK COMPLETE. Vehicle must travel at least 8 miles for reset to occur.
scientia non olet · About LEMON Manuals