Test TC-82B - Speed Control Solenoid Circuits Or Speed Control Power Relay Circuits
NOTE:
Perform TEST TC-82A before proceeding. For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY. For component location see wiring diagram in the WIRING DIAGRAMS
article.
- Using an external ohmmeter, check resistance of S/C on/off switch sense circuit (Yellow/Red wire) between brakelight switch connector and S/C servo connector. If resistance is more than 5 ohms, repair open S/C on/off switch sense circuit and perform TEST VER-4A. If resistance is 5 ohms or less, go to next step.
- Check brakelight switch adjustment. Adjust brakelight switch as necessary and perform TEST VER-4A. If brakelight switch is adjusted properly, replace brakelight switch and perform TEST VER-4A.
NOTE:
A break in test sequence occurs at this point. Sequence skips from TEST TC-82B to TEST TC-87A. No tests have been omitted.