Power Door Lock Test 7A - All Doors (Except Left Front Door) Fail To Unlock
NOTE:
Perform POWER DOOR LOCK TEST 1A
before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For wiring diagrams, refer to WIRING DIAGRAMS
. Refer to DOOR LOCKS - POWER & KEYLESS ENTRY SYSTEM
article. After each repair, perform TEST VER-1A
.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector. Ensure all connectors are clean and tight.
Disconnect passenger's door module 12-pin connector. Using scan tool in ohmmeter mode, measure resistance at terminal No. 5 (Pink/Black wire) on passenger's door module 12-pin connector. If resistance is more than 20 ohms, repair short to ground in Pink/Black wire. If resistance is 20 ohms or less, replace passenger's door module.