LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2000 >> Wrangler SE, Automatic >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Communications >> No Response From Air Bag Control Module
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

No Response From Air Bag Control Module

  1. Remove and inspect fuse No. 9 from fuse block, located behind glove box. If fuse is blown, go to next step. If fuse is okay, go to step  4 .
  2. Using ohmmeter, measure resistance between ground and fused ignition switch output terminal on fuse No. 9 socket. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or greater, replace fuse No. 9.
  3. Ensure ignition is off. Disconnect battery and wait 2 minutes. Disconnect Air Bag Control Module (ACM) connector. Using ohmmeter, measure resistance between ground and fused ignition switch output terminal on fuse No. 9 (Light Green/Yellow wire). If resistance is less than 5 ohms, repair short to ground on Light Green/Yellow wire. Replace fuse No. 9. If resistance is 5 ohms or greater, replace ACM. Replace fuse No. 9.
  4. Using voltmeter, measure voltage between ground and ignition output terminal on fuse No. 9 socket (Light Green/Yellow wire). If voltage is more than 10 volts, go to next step. If voltage is 10 volts or less, repair open Light Green/Yellow wire.
  5. Install fuse No. 9. Ensure ignition is off. Disconnect battery and wait 2 minutes. Disconnect Air Bag Control Module (ACM) connector. Turn ignition on. Using voltmeter, measure voltage between ground and ACM harness connector terminal No. 17 (Light Green/Yellow wire) on ACM harness connector. If voltage is 10 volts or less, repair open Light Green/Yellow wire. If voltage is greater than 10 volts, go to next step.
  6. Turn ignition off. Using ohmmeter, measure resistance between ground and terminal No. 10 (Black/Pink wire) on ACM harness connector. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or greater, repair open Black/Pink wire.
  7. Turn ignition on. Using voltmeter, measure voltage between ground and terminal No. 19 (Violet/Brown wire) on ACM harness connector. If voltage is 1.8-2.6 volts, go to next step. If voltage is not 1.8-2.6 volts, repair open Violet/Brown wire.
  8. Measure voltage between ground and terminal No. 18 (White/Black wire) on ACM connector. If voltage is not 1.8-2.6 volts, repair open White/Black wire. If voltage is 1.8-2.6 volts, replace ACM.
scientia non olet · About LEMON Manuals