LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2002 >> Wrangler Sahara, Automatic >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Body Control Modules >> System Tests >> Communications >> No Response From Powertrain Control Module (SCI Only)
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

No Response From Powertrain Control Module (SCI Only)

NOTE: After all repairs in this test, perform POWERTRAIN VERIFICATION TEST  under VERIFICATION TESTS.

Possible Causes:

Testing

  1. Check Powertrain Control Module (PCM) power and ground circuits. See CHECKING POWERTRAIN CONTROL MODULE POWER & GROUND CIRCUITS  . If problem is not found, go to next step. If any problem is found, repair as necessary and recheck.
  2. If vehicle is equipped with anti-lock brakes, go to next step. If vehicle is not equipped with anti-lock brakes, go to step  5 .
  3. Turn ignition off. Disconnect PCM connector C3. See Figure . Remove scan tool from Data Link Connector (DLC). Check resistance between PCM connector C3 terminal C27 (Pink wire) and ground. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, go to step  6 .
  4. Turn ignition off. Disconnect 25-pin Controller Anti-Lock Brake (CAB) connector. See Figure . Check resistance between CAB harness connector terminal No. 20 (Pink wire) and ground. If resistance is less than 5 ohms, repair short to ground on Pink wire. If resistance is 5 ohms or more, replace CAB. See CONTROLLER ANTI-LOCK BRAKE  under REMOVAL & INSTALLATION.
  5. Turn ignition off. Disconnect PCM connector C3. See Figure . Remove scan tool from Data Link Connector (DLC). Check resistance between PCM connector C3 terminal C27 (Pink wire) and ground. If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, repair short to ground on Pink wire.
  6. Check resistance between PCM connector C3 terminal C29 (Light Green wire) and ground. See Figure . If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, repair short to ground on Light Green wire.
  7. Check resistance of Light Green wire between PCM connector C3 terminal C29 and DLC terminal No. 6. See Figure . If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open on Light Green wire.
  8. Check resistance of Pink wire between PCM connector C3 terminal C27 and DLC terminal No. 7. See Figure . If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open on Pink wire.
  9. If no other problem is found, replace PCM. See POWERTRAIN CONTROL MODULE  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals