LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2004 >> Grand Cherokee Overland, RWD >> Repair and Diagnosis >> Steering >> Steering Linkage >> Steering System Linkage >> Tie Rod End >> Installation
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Tie Rod End: Installation

  1. Screw the tie rod ends into the adjustment sleeve.
  2. Install the tie rod on the steering knuckles and install the nuts.
  3. Tighten the nuts to 47 N.m (35 ft. lbs.). Install new cotter pins and bend end 60°.
  4. Position the adjustment sleeve clamp bolts to their original location and tighten to 41 N.m (30 ft. lbs.).
  5. Install the damper on the tie rod and install the nut.
  6. Tighten the nut to 41 N.m (30 ft. lbs.). Install new cotter pins and bend end 60°.
  7. Install wheel and tire assemblies.
  8. Remove support and lower the vehicle.
  9. Perform toe position adjustment.
scientia non olet · About LEMON Manuals