Installation - 3.7L/4.7L

Fig 1: Removing/Installing Speed Control Cable At Bracket - 3.7L/4.7L

Courtesy of DAIMLERCHRYSLER CORP.

Install end of cable to speed control servo. Refer to INSTALLATION .
Slide speed control cable plastic mount (2) into throttle body bracket.

Fig 2: Removing/Installing Speed Control Cable At Bellcrank - 3.7L/4.7L
Courtesy of DAIMLERCHRYSLER CORP.
Install speed control cable connector (2) onto throttle body bellcrank pin (push rearward to snap into location).

Fig 3: Locating Throttle Cable Release Tab - 3.7L / 4.7L
Courtesy of DAIMLERCHRYSLER CORP.
Slide throttle (accelerator) cable plastic mount (4) into throttle body bracket. Continue sliding until cable release tab (2) is aligned to hole in throttle body mounting bracket.

Fig 4: Removing/Installing Throttle Cable Pin - 3.7L/4.7L
Courtesy of DAIMLERCHRYSLER CORP.
While holding throttle to wide open position, place throttle cable pin (1) into throttle body bellcrank.
Install air intake tube to top of throttle body.
Connect negative battery cable at battery.
Before starting engine, operate accelerator pedal to check for any binding.