Sensor-Throttle Position: Installation: 4.7L
| 1 - THROTTLE BODY |
| 2 - TPS |
| 3 - IAC MOTOR |
| 4 - IAT SENSOR (THREADED TYPE) |
| 5 - MOUNTING SCREWS |
The throttle shaft end of throttle body slides into a socket in TPS. The TPS must be installed so that it can be rotated a few degrees. If sensor will not rotate, install sensor with throttle shaft on other side of socket tangs. The TPS will be under slight tension when rotated.
- Install TPS (2) and two retaining bolts (5). See Fig 1.
- Tighten bolts to 7 N.m (60 in. lbs.) torque.
- Manually operate throttle control lever by hand to check for any binding of TPS.
- Connect TPS electrical connector to TPS.
- Install air duct/air box to throttle body.