LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2006 >> Commander Base, 3.7 K, RWD >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Distribution >> Module-Integrated Power >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module-Integrated Power: Installation

Fig 1: Removing/Installing IPM
GC0029596Courtesy of DAIMLERCHRYSLER CORP.
NOTE: If replacing the Integrated Power Module (IPM) (1) with a new assembly it will be necessary to transfer the circuit protection devices as well as the Front Control Module to the new IPM.
  1. Position the IPM into the vehicle.
  2. Connect the two Front Control Module (FCM) connectors (5).
  3. Connect the two IPM connectors (4).
  4. Position the IPM over the three bracket tabs (2) and apply downward pressure until the retaining clips snap into place securely.
    Fig 2: Removing/Installing Battery Positive Cable
    GC0029597Courtesy of DAIMLERCHRYSLER CORP.
  5. Install the battery positive cable (3) to the IPM B+ terminal stud.
  6. Install the nut (2) to the IPM B+ terminal stud. Tighten the nut to 11.5 N.m (105 in. lbs.).
  7. Close the IPM cover ensuring the locking tabs snap firmly in place.
  8. Connect the battery negative cable.
scientia non olet · About LEMON Manuals