LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2006 >> Commander Base, 4.7 N, RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System (Service Information) >> Wiper Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Wiper Module: Removal

Fig 1: Remove/Install Wiper Module
GC0045762Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. Remove both front wiper arms from the wiper pivots. Refer to FRONT .
  3. Remove the cowl plenum cover/grille panel from over the front wiper module. (Refer to BODY/EXTERIOR/COWL GRILLE - REMOVAL) .
  4. Remove the nut (1) that secures the inboard end of the front wiper module bracket (3) to the stud in the cowl plenum.
  5. Remove the two screws (4) that secure the module bracket to the cowl plenum.
  6. Disconnect the wire harness connector (2) from the connector receptacle for the front wiper motor.
  7. Remove the front wiper module from the cowl plenum as a unit.
scientia non olet · About LEMON Manuals