LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2006 >> Wrangler X, Automatic >> Repair and Diagnosis >> Steering >> Steering Column >> Power Steering System >> Column >> Column >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Steering System: Column: Column: Installation

  1. Align and install column into the steering coupler.
  2. Install column harness and connect harness to switches.
    NOTE: If vehicle is equipped with automatic transmission, install shifter interlock cable. Refer to 42RLE - SERVICE INFORMATION .
  3. Install the upper column shroud.
  4. Install the column onto the mounting studs.
    CAUTION: Lower nuts must be installed and tightened first then the upper nuts in order to prevent damage to the capsules.
  5. Install the lower mounting nuts and tighten to 17 N.m (150 in. lbs.).
  6. Install the upper mounting nuts and tighten to 17 N.m (150 in. lbs.).
  7. Install the steering column coupler bolt and tighten to 49 N.m (36 ft. lbs.).
  8. Center the clock spring (if necessary) and install it on the column, (Refer to ELECTRICAL/RESTRAINTS/CLOCKSPRING - INSTALLATION) .
  9. Install the lower column shroud and install mounting screws.
  10. Install the ignition lock cylinder. (Refer to STEERING/COLUMN/LOCK CYLINDER HOUSING - INSTALLATION) .
  11. Install the knee blocker and the knee blocker cover. INSTRUMENT PANEL .
    NOTE: Do not reuse the old steering wheel bolt (a new bolt must be used)
    NOTE: If equipped with cruise control, connect clock spring harness to cruise switch harness on the steering wheel.
  12. Install the steering wheel and tighten bolt to 54 N.m (40 ft. lbs.).
  13. Install the airbag, (Refer to ELECTRICAL/RESTRAINTS/DRIVER AIRBAG - INSTALLATION) .
  14. Install the negative battery terminal.
scientia non olet · About LEMON Manuals