Diagnostic Test
- 1) REPLACE THE HANDS FREE MODULE IF DTC IS ACTIVE
With the scan tool, read the active DTC's.
Cycle the ignition switch from off to on at least 5 times, leaving the ignition on for a minimum of 90 seconds per cycle.
With the scan tool, read the active DTC's.
Does the scan tool display this DTC as active?
Yes
- Replace and program the Hands Free Module in accordance with the service information.
- Perform BODY VERIFICATION TEST .
No
- If the DTC is stored, check for an intermittent condition. Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals.