LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2007 >> Commander Base, 4.7 P, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Cruise Control Systems >> Speed Control >> Switch-Speed Control >> Removal >> Speed Control Switch
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Speed Control Switch

Fig 1: Identifying Speed Control Switch
GC0010425Courtesy of CHRYSLER LLC
WARNING: Before attempting to diagnose, remove or install any airbag system or related steering wheel and steering column components you must first disconnect and isolate the negative (ground) battery cable. Wait 2 minutes for system capacitor to discharge before further system service. Failure to do so could result in accidental deployment and possible personal injury.
  1. Disconnect and isolate negative battery cable from battery.
  2. Remove airbag module. Refer to RESTRAINTS - SERVICE INFORMATION article.
  3. Unplug electrical connector.
  4. Remove speed control switch mounting screw (1) and remove switch from steering wheel.
scientia non olet · About LEMON Manuals