LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2007 >> Commander Base, 4.7 P, AWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seats >> Seat Heating System (Service Information) >> Heated Seats - Service Information >> Module-Heated Seats >> Diagnosis And Testing >> Module, Heated Seat
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Heated Seat

In order to obtain conclusive testing, the heated seat system and the Controller Area Network (CAN) data bus circuit must be checked. Any diagnosis of the heated seat system should begin with, the use of a scan tool and the appropriate diagnostic service information. 

Refer to the SYSTEM WIRING DIAGRAMS article for complete circuit schematic or connector pin-out information.

NOTE: Vehicles equipped with the heated seat option utilize a low voltage cut-off feature. This feature turns off power to the heated seat system anytime vehicle voltage is below 11.7V or above 15.5V. Be certain to check the vehicle electrical system for proper voltage anytime the power seat system appears inoperative.

Before any testing of the heated seat system is attempted, the battery should be fully-charged.

scientia non olet · About LEMON Manuals