Diagnostic Test
- 1) CHECK FOR ACTIVE INTERNAL FAULTS, IGNITION FAULTS, AND BATTERY FAULTS IN THE OCCUPANT RESTRAINT CONTROLLER (ORC) NOTE: Ensure the battery is fully charged.
With the scan tool, read Occupant Restraint Controller (ORC) DTCs.
Does the scan tool display any active DTCs relating to internal faults, ignition faults, or battery faults?
Yes
- Diagnose and repair the DTCs. Refer to DIAGNOSTIC CODE INDEX table for a complete list of symptoms.
No
- Go to 2).
- 2) VERIFY THAT B1B91-DRIVER SEAT TRACK POSITION SENSOR CONFIGURATION MISMATCH IS ACTIVE
With the scan tool, erase ORC DTCs.
Turn the ignition off, wait 10 seconds and then turn the ignition on.
Wait 2 minutes, and then with the scan tool, read ORC DTCs.
Does the scan tool display active: B1B91-DRIVER SEAT TRACK POSITION SENSOR CONFIGURATION MISMATCH?
Yes
- Go to 3).
No
- Perform *ORC VERIFICATION TEST - VER 1 .
- 3) VERIFY WIRING
Turn the ignition off.
Inspect the driver seat wiring for Seat Position Sensors.
Are Seat Position Sensor(s) present?
Yes
- Replace the ORC in accordance with the Service Information.
- Perform *ORC VERIFICATION TEST - VER 1 .
WARNING: To avoid serious or fatal injury, turn the ignition off, disconnect the battery and wait two minutes before proceeding.WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to take the proper precautions can result in accidental airbag deployment and serious or fatal injury.No
- Perform *ORC VERIFICATION TEST - VER 1 .