Servo Cable

Fig 1: Removing/Installing Throttle Cable Pin - 3.7L/4.7L

Courtesy of CHRYSLER LLC

Disconnect negative battery cable at battery.
Remove air intake tube at top of throttle body.
The accelerator cable must be partially removed to gain access to speed control cable.
Hold throttle in wide open position. While held in this position, slide throttle cable pin (1) from throttle body bellcrank.

Fig 2: Locating Throttle Cable Release Tab - 3.7L / 4.7L
Courtesy of CHRYSLER LLC
Using a pick or small screwdriver, press release tab (2) to release plastic cable mount from bracket. Press on tab only enough to release cable from bracket. If tab is pressed too much, it will be broken. Slide plastic mount (4) towards right side of vehicle to remove throttle cable from throttle body bracket.

Fig 3: Removing/Installing Speed Control Cable At Bellcrank - 3.7L/4.7L
Courtesy of CHRYSLER LLC
Using finger pressure only, disconnect servo cable connector (2) at throttle body bellcrank pin by pushing connector off bellcrank pin towards front of vehicle. DO NOT try to pull connector off perpendicular to the bellcrank pin. Connector will be broken.

Fig 4: Removing/Installing Speed Control Cable At Bracket - 3.7L/4.7L
Courtesy of CHRYSLER LLC
Slide speed control cable plastic mount (2) towards right of vehicle to remove cable from throttle body bracket.
Remove servo cable from servo. Refer to SERVO-SPEED CONTROL Removal/Installation.