Switch-Speed Control

Fig 1: Speed Control Switch

Courtesy of CHRYSLER LLC

The speed control switch is mounted in the steering wheel and wired through the clock spring device under the airbag module.

Fig 2: Switch Removal/Installation

Courtesy of CHRYSLER LLC

1. Connect the electrical connector to speed control switch.
   Fig 3: Switch Top Mounting Screw

   Courtesy of CHRYSLER LLC

   1 - TOP MOUNTING SCREW

2. Install the 2 speed control screw.
3. Tighten the screws (1) to 1.6 N.m (15 in. lbs.). Make sure rubber seal is in place around switch.
   Fig 4: HORN SWITCH

   Courtesy of CHRYSLER LLC
4. Install the horn switch.
5. Install the three mounting fasteners.
6. Connect the electrical connector to the clockspring.
   Fig 5: AIR BAG

   Courtesy of CHRYSLER LLC
7. Install the driver airbag (3). Refer to RESTRAINTS - SERVICE INFORMATION .
   WARNING: Do not connect battery negative cable yet. Refer first to airbag system test. Refer to DIAGNOSIS AND TESTING .
8. Reconnect battery using Airbag System Test procedure in Restraints. Refer to DIAGNOSIS AND TESTING .
9. Close hood.
10. Verify vehicle and system operation.