SENSOR, Intrusion Module: Removal: Receiver
Courtesy of CHRYSLER LLC
- Disconnect and isolate the battery negative cable.
- Remove the overhead console from the headliner. Refer to Electrical - Message Systems/Overhead Console - Removal
.
- Locate the intrusion sensor receiver (3) in the mounting bracket (4) on the left rear corner of the overhead console housing (5).
- Disconnect the take out of the overhead wire harness from the connector receptacle (2) on the forward end of the receiver housing.
- Release the three latch features (1) of the mounting bracket and disengage the receiver from the bracket.