Diagnostic Test
- FINAL DRIVE CONTROL MODULE NOTE: This DTC may set after updating the controller software. Erase this DTC, cycle the ignition off for 10 seconds and recheck. If this DTC resets, proceed with repair procedure. If it does not reset, repair is complete.
- The Final Drive Control Module has detected an internal failure.
View repair
Repair
- Replace the Final Drive Control Module in accordance with the Service Information.
- Perform the FDCM VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Final Drive Control (FDCM) - Standard Procedure .
- The Final Drive Control Module has detected an internal failure.