Diagnostic Test

Perform Power Seat System Verification Test
1. Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
2. Ensure that all accessories are turned off.
3. Ensure that the battery is fully charged.
4. Turn the ignition on.
5. If either the Memory Seat Module or the Driver Horizontal Seat Adjuster Motor/Seat Track was replaced, the MSM Standard Routine must be performed using the scan tool.
6. With the scan tool, record and erase DTCs from all modules.
7. Operate the driver seat in all positions.
8. With the Memory Switch on the Driver's Door, program the Driver's Seat No. 1 Button to a desired position and Driver No. 2 Button to a different position.
9. Verify that both Memory positions can be recalled from the RKE transmitter and the Memory Switch on the Driver's Door.
10. Turn the ignition off, wait 10 seconds, and then turn the ignition on.
11. With the scan tool, select ECU View.
12. Check for DTCs in the modules.
  Are DTCs present in any of the modules or is the original condition still present?
  
  Yes
  - The repair is not complete. Refer to DIAGNOSTIC CODE INDEX for the DTC that is still present.
  No
  - The repair is complete.