Diagnostic Test

INTERMITTENT CONDITION
1. Turn the ignition on.
2. Using the scan tool, clear all FCM DTCs.
3. Turn the High Beam Headlamps on.
4. With the scan tool read the DTC information.
  Does the scan tool read: B1633-LEFT HI BEAM CONTROL CIRCUIT LOW?
  
  Yes
  - Go to step 2
  No
  - The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Front Control (FCM) - Standard Procedure .
(L33) LEFT HIGH BEAM OUTPUT CIRCUIT

Fig 1: Checking Left High Beam Output Circuit Schematic
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Disconnect the FCM C2 harness connector.
3. Disconnect the Left Headlamp harness connector.
4. Measure the resistance between ground and the Left High Beam Output circuit.
  Is the resistance below 5.0 Ohms?
  
  Yes
  - Repair the (L33) Left High Beam Output circuit for a short to ground condition.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Front Control (FCM) - Standard Procedure .
  No
  - Replace the Front Control Module (FCM) in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Front Control (FCM) - Standard Procedure .