Diagnostic Test

TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. Press the Memory Set Switch several time in all positions.
4. Cycle the ignition from on to off 3 times.
5. Turn the ignition on.
6. With the scan tool, read DTCs.
  Does the scan tool display: B1D4C-MEMORY SWITCH INPUT CIRCUIT HIGH?
  
  Yes
  - Go to step 2
  No
  - The conditions that caused this code to set are not present at this time. Using the SYSTEM WIRING DIAGRAMS as a guide, inspect the wiring and connectors.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Front Control (FCM) - Standard Procedure .
CHECK THE DRIVER WINDOW/DOOR LOCK SWITCH FOR A SHORT TO VOLTAGE

Fig 1: Checking Driver Window/Door Lock Switch For A Short To Voltage
Courtesy of CHRYSLER LLC
1. With the scan tool, erase DTCs.
2. Turn the ignition off.
3. Disconnect the Driver Window/Door Lock Switch C2 connector.
4. Cycle the ignition 3 times.
5. Turn the ignition on.
6. With the scan tool, read DTCs.
  Does the scan tool display: B1D4C-MEMORY SWITCH INPUT CIRCUIT HIGH?
  
  Yes
  - Go to step 3
  No
  - Replace the Driver Window/Door Lock Switch in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Front Control (FCM) - Standard Procedure .
CHECK THE (G160/G161) RIGHT/LEFT DOOR LOCK SWITCH MUX CIRCUIT FOR A SHORT TO VOLTAGE

Fig 2: Checking Left Door Lock Switch Mux Circuit For Short To Voltage
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Disconnect the Driver Door Module C2 connector.
3. Turn the ignition on.
4. Measure the voltage of the (G160/G161) Right/Left Door Lock Switch Mux circuit.
  Is the voltage above 0.2 volts?
  
  Yes
  - Repair the (G160/G161) Right/Left Door Lock Switch Mux circuit for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Front Control (FCM) - Standard Procedure .
  No
  - Go to step 4
CHECK THE (P439) MEMORY SELECT SWITCH MUX CIRCUIT FOR A SHORT TO VOLTAGE

Fig 3: Checking Memory Select Switch MUX Circuit For A Short To Voltage
Courtesy of CHRYSLER LLC
1. Turn the ignition off.
2. Disconnect the Driver Door Module C3 connector.
3. Turn the ignition on.
4. Measure the voltage of the (P439) Memory Select Switch Mux circuit.
  Is the voltage above 0.2 volts?
  
  Yes
  - Repair the (P439) Memory Select Switch Mux circuit for a short to voltage.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Front Control (FCM) - Standard Procedure .
  No
  - Replace the Driver Door Module in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to DTC-Based Diagnostics/MODULE, Front Control (FCM) - Standard Procedure .