Diagnostic Test

TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. Using the scan tool, record and erase DTCs
3. Move the seat switch in the horizontal position three times.
4. Using the scan tool, read DTCs.
  Does the scan tool display B1D6E-SEAT HORIZONTAL POSITION SENSOR CIRCUIT HIGH?
  
  Yes
  - Go to step 2
  No
  - The conditions that caused this code to set are not present at this time. Using the SYSTEM WIRING DIAGRAMS as a guide, inspect the wiring and connectors.
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Memory Seat (MSMD) - Standard Procedure .
CHECK THE (G401) DRIVER SEAT HORIZONTAL POSITION SENSE VOLTAGE
1. Disconnect the Driver Horizontal Seat Adjuster Motor.
  NOTE: Check connectors - Clean and repair as necessary.
2. With the scan tool erase DTCs
3. Move the seat switch in the horizontal positions three times.
4. Using the scan tool, read DTCs.
  Does the same DTC reset?
  
  Yes
  - Inspect the position sense wire for a possible short to voltage from another circuit, if OK replace the Memory Seat Module.
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Memory Seat (MSMD) - Standard Procedure .
  No
  - Inspect the position sense wire for a possible intermittent short to voltage from another circuit, if OK replace the Driver Horizontal Seat Adjuster Motor assembly.
  - Perform the POWER SEAT SYSTEM VERIFICATION TEST. See DTC-Based Diagnostics/MODULE, Memory Seat (MSMD) - Standard Procedure .