LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2010 >> Commander 4WD V6-3.7L >> Repair and Diagnosis >> Powertrain Management >> Transmission Control Systems >> Relays and Modules - Transmission and Drivetrain >> Relays and Modules - A/T >> Shift Interlock Control Module >> Technical Service Bulletins >> Recalls >> Recall - Wireless Ignition Node Receiver >> Service Procedure >> B. (DS/DJ/D2) Ram 1500/2500 Truck WIN Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

B. (DS/DJ/D2) Ram 1500/2500 Truck WIN Replacement

1. Disconnect and isolate the battery negative cable.

2. Remove the instrument panel knee bolster (Figure 1).





3. Remove the four Wireless Ignition Node (WIN) receiver mounting screws (Figure 2).

4. Disconnect the WIN electrical connector.

5. If equipped, remove the WIN antenna connector.

6. Remove and discard the original WIN from the instrument panel opening.

7. Connect the WIN electrical connector to the new WIN receiver.

8. If equipped, connect the WIN antenna connector to the new WIN receiver.

9. Install the WIN receiver into the instrument panel.





10. Install the four WIN mounting screws and tighten securely (Figure 3).

11. Install the instrument panel knee bolster (Figure 1).

12. Connect the negative battery cable.

13. Continue with Section E. Obtaining Vehicle Personal Identification Number (PIN).
scientia non olet · About LEMON Manuals