LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2011 >> Compass Base, 2.0 A, Standard >> Repair and Diagnosis (Single Page) >> Restraints >> Restraints Control Systems >> Occupant Restraint Controller (Orc) - Airbag System Intermittent Test, Pre-Diagnostic Procedure & System Verification Test >> Standard Procedure >> Standard Procedure - Airbag System Verification Test >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. AIRBAG SYSTEM VERIFICATION TEST 
    1. Remove all special tools and jumper wires and reconnect all previously disconnected components - except the Battery.
      WARNING:

      Turn the ignition on, then reconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

    2. Connect the scan tool to the Data Link Connector - use the most current software available.
    3. With the scan tool, erase stored DTCs in all Airbag System Modules.
    4. Turn the ignition off, and wait 30 seconds, then turn the ignition on.
    5. Wait one minute, and read active DTCs in all Airbag System Modules.
    6. Read the stored DTCs in all Airbag System Modules.

      Are any DTCs present or if the original condition still present?

      Yes 

      No 

      • Repair is complete.
scientia non olet · About LEMON Manuals