Diagnostic Test

TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, erase all the DTCs.
3. Operate the Mirror Switch in all directions several times.
4. Cycle the ignition from on to off three times.
5. Turn the ignition on.
6. With the scan tool, read the DTCs.
  Does the scan tool display active: B1D0D-DRIVER MIRROR VERTICAL POSITION SENSOR INPUT CIRCUIT HIGH?
  
  Yes
  - Go To 2.
  No
  - The condition that caused this symptom is currently not present. Check for an intermittent condition by inspecting the related wiring harness for chafed, pierced, pinched and partially broken wires. Also, inspect the related connectors for broken, bent, pushed out, spread, corroded or contaminated terminals. Repair as necessary.
  - Perform the BODY VERIFICATION TEST. Refer to Standard Procedure .
INSPECT MIRROR CONNECTIONS
1. Turn the ignition off.
2. Disconnect the Driver Outside Rearview Mirror connector at the Driver Door Module harness connector.
3. Inspect the wiring and connectors between the mirror and the Driver Door Module.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the BODY VERIFICATION TEST. Refer to Standard Procedure .
  No
  - Go To 3.
MIRROR ASSEMBLY
1. Turn the ignition off.
2. Replace the Driver Outside Rearview Mirror Assembly.
3. Turn the ignition on.
4. Operate the Mirror Switch in all directions several times.
5. With the scan tool, read the DTCs.
  Does the scan tool display active: B1D0D-DRIVER MIRROR VERTICAL POSITION SENSOR INPUT CIRCUIT HIGH?
  
  Yes
  - Replace the Driver Door Module in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to Standard Procedure .
  No
  - Test Complete.
  - Perform the BODY VERIFICATION TEST. Refer to Standard Procedure .