LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2012 >> Compass Limited, AWD, Automatic CVT, CVT2L >> Repair and Diagnosis >> External Pages >> Different car >> Section 380 (Electronic Control Modules (Service Information)) >> Module, Intrusion Transceiver >> Removal >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Intrusion Transceiver: Removal: Removal

WARNING: This page is about a different car, the 2015 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Front Overhead Console
GC0146811Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative cable from the battery. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector before disconnecting the negative cable from the battery.
  2. Remove the overhead console (1) from the headliner. Refer to CONSOLE, OVERHEAD, REMOVAL .
    Fig 2: Motion Sensor Connector
    GC0146812Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the intrusion module sensor pigtail wire harness connector (1) from the Intrusion Transceiver Module (ITM) (2).
  4. Release the latch features that secure the ITM to the overhead console housing.
  5. Remove the ITM from the overhead console housing.
scientia non olet · About LEMON Manuals