LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2012 >> Compass Limited, AWD, Standard >> Repair and Diagnosis (Single Page) >> Electrical >> Gauges >> Universal Transmitter >> Standard Procedure >> Reprogramming HOMELINK® Transmitter Codes >> CANADIAN Programming/Gate Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

CANADIAN Programming/Gate Programming

Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission which may not be long enough for HomeLink® to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to "time-out" in the same manner.

If you live in Canada or you are having difficulties programming a gate operator by using the "Programming" procedures (regardless of where you live), replace "Programming HomeLink®" step 3  with the following:

NOTE:

When programming a garage door opener or gate operator, it is advised to unplug the device or move the vehicle out of range during the "cycling" process to prevent possible overheating.

  1. 3. Continue to press and hold the HomeLink® button while you press and release every two seconds  ("cycle") your hand-held transmitter until the frequency signal has successfully been accepted by HomeLink®. (The indicator light will flash slowly and then rapidly.) Proceed with "Programming" step 4 to complete.
scientia non olet · About LEMON Manuals