Diagnostic Test

WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

CONFIGURE THE INTRUSION TRANSCEIVER MODULE
1. With the scan tool under miscellaneous functions, perform the initialization procedure for the Intrusion Transceiver Module.
2. Turn the ignition off and remove the key from the ignition.
3. Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
4. Disarm the VTSS.
5. With the scan tool, read DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Replace the Intrusion Transceiver Module in accordance with the Service Information. Refer to MODULE, INTRUSION, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Test complete.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .