Module, Anti-Lock Brake System: Removal: Removal

WARNING: This page is about a different car, the 2012 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative (-) battery cable from battery post and isolate.

Fig 1: ABM Connector And Lever
Courtesy of CHRYSLER GROUP, LLC

NOTE:
To disconnect the ABM wiring connector in the following step, depress the tab (1) in the center of the connector and lift the release lever (2), rotating it upward to the top of the connector, or until the connector is fully released from the module socket.

Fig 2: ABM Wiring Connector & ICU
Courtesy of CHRYSLER GROUP, LLC
Disconnect the wiring connector from the ABM.

Fig 3: Antilock Brake Module, Screws And Hydraulic Control Unit
Courtesy of CHRYSLER GROUP, LLC
Remove four screws (1) attaching antilock brake module (ABM) (2) to hydraulic control unit (HCU).

Fig 4: ABM And HCU
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
When removing ABM from HCU, be sure to completely separate the two components (approximately 38 mm (1.5 inches)) before removing ABM. Otherwise, damage to the pressure sensor will result requiring HCU replacement.
Slide ABM (1) off HCU (2).
Remove ABM from vehicle.