Section 388 (Front Axle): Installation: Installation

WARNING: This page is about a different car, the 2015 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Front Axle

Courtesy of CHRYSLER GROUP, LLC

Install front axle assembly (1) into position. Install and tighten axle housing-to-engine bolts to 65 N.m (48 ft. lbs.).

Fig 2: Power Steering Return Line & Clips
Courtesy of CHRYSLER GROUP, LLC
Install power steering return line to cradle by fastening clips (1).

Fig 3: Front Drive Axle Housing Support Bracket
Courtesy of CHRYSLER GROUP, LLC
Install axle assembly support bracket (1) and torque bolts to 28 N.m (21 ft. lbs.).
Install RH catalytic converter/exhaust pipe assembly. Refer to CONVERTER, CATALYTIC, INSTALLATION .
Install front propeller shaft. Refer to INSTALLATION .
Install intermediate shaft. Refer to REMOVAL .
Install both front halfshafts. Refer to INSTALLATION .

Fig 4: Fluid Fill Plug Location
Courtesy of CHRYSLER GROUP, LLC
Fill axle with 600ml (0.64 qts.) of Mopar® 75W-90 Synthetic Gear Lubricant. Fluid level should be at or near bottom of fill hole. Torque fill plug (1) to 30 N.m (22 ft. lbs.).
Lower vehicle.