LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2012 >> Compass Limited, FWD, Automatic CVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 375 (Engine Cooling System) >> Engine >> Radiator, Engine Cooling >> Installation >> 3.6L
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Radiator, Engine Cooling: Installation: 3.6L

WARNING: This page is about a different car, the 2015 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Upper Radiator Mounting Brackets Bolts
GC0144643Courtesy of CHRYSLER GROUP, LLC
  1. Install the radiator into engine compartment and seat the lower rubber isolators into the mounting holes of the lower radiator support.
  2. Install the radiator isolator (1). Tighten bolts (2) to the proper specification. Refer to SPECIFICATIONS  .
    Fig 2: Support Bolt
    GC0144644Courtesy of CHRYSLER GROUP, LLC
  3. Position the condenser on radiator and loosely install the support bolt.
  4. Install upper and lower mounting bolt. Tighten bolts to the proper specification. Refer to SPECIFICATIONS  .
  5. Tighten bolt (2) located between the cooler lines to the proper specification. Refer to SPECIFICATIONS  .
    Fig 3: Air Deflectors
    GC0144642Courtesy of CHRYSLER GROUP, LLC
  6. Install the air deflectors (1).
  7. Position the hood latch release cable (2) through the notch in deflector.
  8. Install the front bumper fascia. Refer to FASCIA, FRONT, INSTALLATION .
  9. Raise and support the vehicle Refer to HOISTING, STANDARD PROCEDURE .
    Fig 4: Lower Radiator Hose
    GC0095212Courtesy of CHRYSLER GROUP, LLC
  10. Install the lower radiator hose (1).
    Fig 5: Lower Engine Cover & Front Air Shield
    GC0144481Courtesy of CHRYSLER GROUP, LLC
  11. Install the lower engine cover.
  12. Remove support and lower vehicle.
  13. Install the cooling fan. Refer to FAN, COOLING, INSTALLATION .
    Fig 6: Radiator Fan Assembly
    GC0079911Courtesy of CHRYSLER GROUP, LLC
  14. Install the upper radiator upper hose (2). Align hose so it does not interfere with the accessory drive belt or engine.
  15. Connect the negative battle cable.
  16. Fill the cooling system with coolant. Refer to STANDARD PROCEDURE .
  17. Operate the engine until it reaches normal operating temperature. Check the cooling system and automatic transmission for the correct fluid levels.
scientia non olet · About LEMON Manuals