Diagnostic Test
WARNING: This page is about a different car, the 2015 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
CHECK IF THE DTC IS ACTIVE
- With a scan tool, read and record ITM DTCs.
- With the scan tool, erase ITM DTCs.
- Turn the ignition off and remove the key from the ignition.
- Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
- Disarm the VTSS.
- With the scan tool, read ITM DTCs.
Does the scan tool display this DTC as active?
Yes
- Using the scan tool under Miscellaneous functions initialize the Intrusion Transceiver Module.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Test complete. The DTC is not active at this time.
- Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .