Heater, Engine Block: Installation: 3.6L
WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Thoroughly clean the cylinder block heater cavity.
- Insert the engine block heater assembly (1) and tighten the bolt (2) to the proper specification. Refer to TECHNICAL SPECIFICATIONS .CAUTION:
To prevent damage, the power cord must be secured in its retainer clips, and not positioned so it could contact linkages or exhaust manifolds.
- Attach the power cord to the block heater.
- Install the A/C compressor. Refer to COMPRESSOR, A/C, INSTALLATION .
- Remove the support and lower the vehicle.