Diagnostic Test

CHECK FOR AN ACTIVE DTC
NOTE:
Before proceeding with this diagnostic procedure, verify the Left and Right Multifunction Switch and Clockspring harness connectors are properly seated and verify proper pin terminal tension. A loose connection at any of these connectors may cause this DTC to set. Inspect the Steering Wheel wiring harness for damage. Repair if necessary.
1. Turn the ignition on.
2. Actuate the Rear Washer.
3. With the scan tool, read DTCs.
  Does the scan tool display this DTC as Active?
  
  Yes
  - Replace the Right Multifunction Switch in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.