LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Jeep >> 2012 >> Wrangler Rubicon, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Power Distribution) >> Module, Totally Integrated Power (TIPM) >> Standard Procedure >> Standard Procedure - Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Standard Procedure - Programming

WARNING: This page is about a different car, the 2016 Jeep Wrangler and 2015 Jeep Wrangler. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a battery charger.
  2. Verify that the charging rate provides approximately 13.5 volts.
    NOTE:

    Do not allow the charger to time out during the reconfiguration process. Set the battery charger timer (if so equipped) to continuous charge.

  3. Connect the scan tool to the dealer's network drop.
  4. Connect the scan tool to the vehicle.
  5. Place the Ignition in the "RUN" position, then Power "ON" the scan tool.
  6. Select "ECU View".
  7. Select "TIPMCGW" or "FCMCGW".
  8. Select "MISC".
  9. Select "Restore Vehicle Configuration".
  10. Follow prompts on scan tool to complete the reconfigure procedure.
  11. Once complete, Wait one minute and turn the ignition key to the "OFF" position.
  12. Remove the scan tool unit, cable and charger from the vehicle.
  13. Verify proper operation.
scientia non olet · About LEMON Manuals