Diagnostic Test

VERIFY THE DTC IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, record and erase Adaptive Cruise Control (ACC) DTCs.
3. Cycle the ignition from off to on.
4. With the scan tool, read ACC DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Go To 2
  No
  - Go To 5
CHECK FOR BODY CONTROL MODULE (BCM) DTCS
1. With the scan tool, read BCM DTCs.
  Are there any BCM CAN Bus DTCs present?
  
  Yes
  - Refer to the BODY CONTROL MODULE (BCM) - DIAGNOSTIC CODE INDEX article and perform the appropriate diagnostic procedure.
  No
  - Go To 3
CHECK FOR OCCUPANT RESTRAINT CONTROLLER (ORC) DTCS
1. With the scan tool, read ORC DTCs.
  Are there any ORC DTCs present?
  
  Yes
  - Refer to the OCCUPANT RESTRAINT CONTROLLER (ORC) - DIAGNOSTIC CODE INDEX article and perform the appropriate diagnostic procedure.
  No
  - Go To 4
CHECK OTHER MODULES FOR DTCS
1. With the scan tool, read DTCs.
  Are there any other modules reporting implausible communication DTCs against the ORC?
  
  Yes
  - Replace and program the Occupant Restraint Controller (ORC) in accordance with the Service Information.
  - Perform the ADAPTIVE CRUISE CONTROL VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Using the schematics as a guide, check the ACC module pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace and program the Adaptive Cruise Control (ACC) module in accordance with the Service Information. Refer to MODULE, ADAPTIVE CRUISE CONTROL, REMOVAL .
  - Perform the ADAPTIVE CRUISE CONTROL VERIFICATION TEST. Refer to STANDARD PROCEDURE .
CHECK THE WIRING AND CONNECTORS
1. The conditions necessary to set the DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this module. Wiggle the wiring and connectors while checking for shorted and open circuits.
3. Check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
4. Check Service Bulletins for any possible causes that may apply.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the ADAPTIVE CRUISE CONTROL VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Test complete.