Charging System (Service Information): Generator: Removal: 3.2L

Perform the fuel system pressure release. Refer to FUEL SYSTEM PRESSURE RELEASE PROCEDURE .
Disconnect and isolate the battery negative cable.

Fig 1: Air Filter Housing Body
Courtesy of CHRYSLER GROUP, LLC
Remove the air filter housing body (1). Refer to BODY, AIR CLEANER, REMOVAL .
Raise and support the vehicle.

Fig 2: Removing/Installing Accessory Drive Belt
Courtesy of CHRYSLER GROUP, LLC
Remove the right side front wheel.
Remove the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .

Fig 3: Air Intake Inlet Tube
Courtesy of CHRYSLER GROUP, LLC
Remove the air intake inlet tube (2).
Raise the vehicle.

Fig 4: Removing/Installing Belly Pans
Courtesy of CHRYSLER GROUP, LLC
Remove the belly pan (1).
NOTE:
The A/C compressor bolts are removed to allow for extra clearance for the generator to pass between the upper and lower frame.

Fig 5: Generator Field Electrical Connector & B+ Retainer
Courtesy of CHRYSLER GROUP, LLC
Remove the A/C compressor bolts.
Disconnect the field generator harness connector (1).
Remove the B+ cable (3) from the generator.
Lower the vehicle.
Using a suitable jack. Support the engine.

Fig 6: Removing/Installing Right Engine Mount Assembly
Courtesy of CHRYSLER GROUP, LLC
Remove the upper engine mount bolts to engine mount bracket (2, 3).

Fig 7: Fuel Line At Fuel Rail
Courtesy of CHRYSLER GROUP, LLC
Remove the fuel line (2) at the fuel rail.

Fig 8: Generator & Mounting Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove the lower generator mounting bolt (3).
Remove the top two generator mounting bolts (1).

Fig 9: Generator & Frame Rails
Courtesy of CHRYSLER GROUP, LLC
Carefully remove the generator (1) between the upper and lower frame rail (2).